TOP

ISED

Innovation, Science and Economic Development Canada

SCROLL

ISED 01
(캐나다: mmWave) 100 GHz 이상 대역 인증 가능

ISED 는 2024년 5월 9일에 100 GHz 이상 대역의 mmWave 를 사용하는 Unlicensed Device (비면허기기) 에 대한 새로운 규격인 RSS-259 Issue 1을 제정하였으며, 주요 내용은 다음과 같습니다.

  • 1) 주파수 대역: 116-123 GHz, 174.8-182 GHz, 185-190 GHz and 244-246 GHz
  • 2) 대상 기기: SRD (Short Range Device), Fixed point-to-point device
  • 3) Technical Requirements
    • SRD: 40 dBm AVE. EIRP, 43 dBm Peak
    • Outdoor SRD: 10 dBm AVE TRP or conducted power
      (단, Emission BW 가 100 MHz 를 넘지 않는 경우: Peak EIRP Limit = Peak Limit * BW/100)
  • 4) User manual statement 추가 됨.
    • The use of this device is on a “no-interference, no-protection” basis. Do not install or operate on board an aircraft or a satellite.”
    • Outdoor equipment: Do not aim upwards towards the sky
  • 5) Indoor SRD 의 경우, Label 문구 추가: For indoor use only
출처: RSS-259 Issue 1, Licence-Exempt Radio Apparatus Operating in the Frequency Bands 116-123 GHz, 174.8-182 GHz, 185-190 GHz and 244-246 GHz
ISED 02
(캐나다: RF Exposure) WPT RF Exposure Notice 발행

ISED는 5월 17일, 무선전력전송 기기(Wireless Power Transfer)의 RF Exposure 평가를 위한, Notice를 발행하였습니다. RSS-102.NS.MEAS 규격의 Sec.5.1 에 따른 E-field 평가를 위하여, DASY module WPT 측정시스템을 허용하였습니다.

출처: Notice 2024-DRS0005
ISED 03
(캐나다: RF Exposure) Nerve Stimulation RF Exposure Notice 발행

ISED는 5월 17일, Nerve Stimulation RF Exposure 평가를 위해 curve-fitting 기법을 이용하는 Guidance를 발행하였습니다. RSS-102.NS.MEAS or SPR-002 에 따른 평가를 위하여, Biot-Savart 법칙을 이용한 curve-fitting 기법을 예시로 제시하였습니다.

출처: Notice 2024-DRS0004
ISED 04
(캐나다: 60 GHz) 60 GHz 대역 등 비 면허 기기의 RSS-210 규격 변경

2024년 6월 25일에 비 면허 기기에 대한 무선 규격인 RSS-210 Issue 11을 발행 하였습니다. 해당 규격은 제품 구분 별로 Annex A 부터 K까지 구성하고 있으며, 이번 개정 사항에는 Annex A, B, C, E, F, G, J 및 K 가 포함 되었습니다. 주요 변경 된 사항은 57-71 GHz 대역에서 새로운 제품들 (ex. 60 GHz Hot Car Sensor, UAS 등)을 인증 받을 수 있도록 하기 위해, Requirement 를 전체적으로 개정 하였습니다. 주요 내용은 하기를 참조 바랍니다.

  • 1) Field disturbance sensors(FDS) 의 fixed use 조건 삭제
  • 2) 주파수 대역별 사용 용도에 따른, EIRP limit 및 off time 조건 추가
Device Frequency bands (GHz) Power limit (Peak EIRP) Off Time Requirement: off times (>=2 ms) must sum to at least X ms per 33 ms interval
All other than FDS 57-71 GHz -10 dBm Peak conducted Power
10 dBm Peak EIRP
FDS All FDS other than bellows
57-71 GHz
Ave. 40 dBm
Peak 43 dBm
FDS 61-61.5 Ave. 40 dBm e.i.r.p
Peak. 43 dBm e.i.r.p
Any emission outside of the 61-61.5 GHz but still within 57-71 GHz: Peak 10 dBm/peak 13 dBm
500 MHz bandwidth or less
FDS 57-59.4 Peak e.i.r.p 20 dBm (Indoor)
Peak e.i.r.p 30 dBm (outdoor)
FDS 57-61.56 3 dBm peak e.i.r.p
FDS 57-61.56 20 dBm peak e.i.r.p 16.5 ms off time per 33 ms
FDS 57-64 Peak eirp 14 dBm 25.5 ms off time per 33 ms
FDS 57-64
outdoor operation (temporary or permanently) or vehicular uses (excluding in-cabin)
Peak eirp 20 dBm 16.5 ms off time per 33 ms
FDS Pulsed FDS 57-64 Max. pulse duration of 6ns
Ave. EIRP 13 dBm
61.5-64 GHz: 5 dBm ave. integrated EIRP
Peak shall not exceed 20 dB above the max. permitted average emission
Duty cycle shall not exceed 10 % during any 0.3 µs time window
FDS installed on UAVs 60-64 GHz Peak eirp 20 dBm 16.5 ms off time per 33 ms
Other than FDS Other than Fixed point-to-point Ave. eirp 40 dBm
Peak. eirp 43 dBm
Peak Conducted Power 500 mW
출처: RSS-210 — Licence-Exempt Radio Apparatus: Category I Equipment, Issue 11